Measuring principle
 

   LMTR800 series radar level gauge is a 26G high-frequency radar type level measuring instrument, output 4-20mA analog signal, measure

The maximum distance can reach 70 meters. The antenna is further optimized, and the new fast microprocessor can carry out higher rate signals

Analytical processing allows the instrument to be used in: very complex measurement conditions for reactors or solid silos.

   High-frequency microwave pulses emit narrower microwave pulses, which are transmitted downward through the antenna. The microwaves are reflected back when they touch the surface of the measured medium.

Received again by the antenna system and transmitted to the electronic circuit part is automatically converted into a level signal. (Because microwave propagation speed is extremely fast,

(The time it takes for the electromagnetic wave to reach the target and return to the receiver through reflection is almost instantaneous)

Features
 

 The radar level gauge uses a transmission frequency of up to 26GHZ, and therefore has:

● Non-contact radar, no wear and no pollution

● Small antenna size, easy to install

● Short wavelength, better reflection on inclined solid surface

● The measurement dead zone is smaller, and it will also achieve good results for small tank measurement

● The beam angle is small, the energy is concentrated, while enhancing the echo capability, it is also helpful to avoid interference

● Almost not affected by corrosion and foam

● Almost not affected by changes in water vapor, temperature and pressure in the atmosphere

● Severe dust environment will not affect the electromagnetic wave work

● High signal-to-noise ratio, even better performance under fluctuating conditions

● High frequency is the best choice for measuring solid and low dielectric constant medium